Hello everyone,
@FabLabSUPSI we have two laser cut trotec 400. (I saw that the last thread on the laser Trotec 300 is not updated anymore) However, we will post here our discussion about technical issues or solutions.
At the moment, we have problems with the procedure for cutting files with Autocad and Archicad software.
Have you ever tried to send files to JobControl Trotec directly from Autocad and Archicad?
If so, what settings should we consider to create a lasercuttable file?
If not, what are the settings or the right procedure to create a clean .dxf out of an Autocad and Archicad software?
thank you for your support!